Explain the characteristics of common components of automatic edge banding machine

　　Explain the characteristics of common components of automatic edge banding machine:
　　1.Adjust the guide plate:The function of the guide plate is to ensure that the edge sealing surface of the to-be-sealed plate is parallel to the moving direction of the conveyor belt when placing the edge sealing plate,so as to ensure that the edge sealing quality will not be a problem.Subsequent edge sealing process.When placing the plate to be sealed,first make sure that both ends of the plate to be sealed are fixed on the working surface of the guide plate(as shown in the figure below).If the board part enters the conveyor,you will find that the front and rear of the board are connected to the guide at the same time.The working surface of the civilized guide plate is not parallel to the moving direction of the conveyor belt,so the guide plate needs to be adjusted.
　　2.Pre-milling system:The pre-press motor can correct the plate workpiece before pressing the film.The workpieces must be parallel at right angles and trimmed to the specified size.The use of the pre-milling motor is done by a pressure cylinder that will lift the tool before reaching the end of the workpiece and return the tool to the working position after the tool has passed the end of the workpiece.Pre-milling equipment only allows qualified professionals to operate the machine!Turn off the switch and high pressure air on the assembly to set up and change tools!When the safety circuit is opened,the transmission power is turned off and the motor is braked.When the shroud is closed,the transmission will restart.The shield cannot be closed until 30 seconds after it is opened.Otherwise,it will fail.
　　3.Sealing edge tray:The sealing edge tray is used to place coil type or fixed length edge film and guide the work.The drive is driven by chains on two rollers,and rubber-driven rollers are used to handle thin and damaged lamination materials.Pin wheels are used to process cut-to-length wooden strips,and steel knurled transfer rollers are used to process PVC or acrylic and similar materials.
　　4.Gluing system:a coating system for applying glaze on the edge of the workpiece,the melted dissolved air fills the glaze cement,the plastic will melt in the plastic container,the spin coating shaft sticks the hot glaze cement to the workpiece,the quantitative control device Supply,adjust the spiral roller,vertical,adjust the distance between the glue shaft and the workpiece,the distance between the glue shaft and the guide rail,the coating system can be installed flexibly,the maximum distance is 0.5 mm.
　　5.Rolling system:The rolling system compacts the film on the workpiece during this process.The rolling system is the sequence and number of pressure wheels that are put into use.The turning pre-pressing roller follows the two tapered negative pressure rollers,first pressing the pressure film to the corners of the edge of the workpiece.Z The last roller is cylindrical.The preload roller is driven by an electric motor through a transmission system,while the composite roller has no transmission power.The pressure strength is related to the pressure film material and must be known through experiments.